–
Another simple model for → Ikego. A storage box, built mostly from existing parts we already had. We just added two new parts (all info below the pictures).
Shots ↓
–
in (slow) motion ⇢
and fast ⇢
–
click to open ↓
↓
- You can have it with or without wheels, with or without a lid and with or without a handlebar, as shown in the pictures.
- The board on the bottom rests only on the nuts of the bolts that go into the side of the VITO box.
- The beads on the lid are there to prevent the lid from sliding away.
- If the VITO box is well made, you can even sit on it. It is basically also a stool.
- Wheel assembly: See the picture below. The wheel runs on 2 M6 nuts. The order is: nut|washer|box|washer|nut|nut|washer|head of bolt. This is not very elegant, but it works. But it can easily be improved. If you want to go with the solution below you should replace the nuts with lock nuts.
–
click to open ↓
–
click to open ↓
↓
1 board
Basic info
- What is it: a board
- Material: strong
- Measures: 320mmx320mm
- Holes: none
Tolerance
Get the part
- Buy: Only as local make
- Make: No instructions available
Introduced by
- Designer: Lars Zimmermann
- Open: Shared under IPP 1.0.
2 bead
Basic info
- What is it: bead
- Material: strong
- Measures: 16x16x16mm
- Holes: one center hole ⌀ 4mm
Tolerance
Get the part
- Buy: Readily available in stores, search for: “beads, drilled”
- Make: No instructions available
Introduced by
- Designer: Lars Zimmermann
- Open: I bought this part off the shelf. It might be prior art but I don’t guarantee this.
*
*
Disclaimer: This model is just a concept and not fully tested. You should not assume that it works as indicated and I am not saying that it does. I disclaim any responsibility or liability for any damage caused during the construction and use of products based in whole or in part on the concept shown here. All information is provided for your use at your own risk.
This post (including images) is shared under the Creative Commons Attribution 4.0 License.